Grizzco Blaster
The Grizzco Blaster is a Salmon Run rare weapon in Splatoon 2 and Splatoon 3. It appears to be an illegally modified Blaster.
The weapon is a short-ranged blaster with an extremely high firing speed probably due to most of its frame being stripped down and modified. The range of the weapon is comparable to the Luna Blaster while the firing rate of the weapon is much greater than even the Clash Blaster.
Appearance
The Grizzco Blaster is somewhat similar in appearance to the Blaster. However, the front has been completely stripped off, revealing the metal frame and inner workings. Multiple red and orange wires and metal blocks can be seen. Sticking out of the top are four yellow pill bottles with white caps, the contents of which are unknown. The ink tank has a dark green Grizzco Industries logo on the side.
Splatoon 2
Basic information | |
---|---|
Category | Main |
Class | Shooter |
Specifications | |
Base damage | 35 (Min. splash) 50 (Direct hit) |
Ink consumption | 3% |
The Grizzco Blaster is a rare weapon only available during Salmon Run wildcard rotations. It was first available on 16 September 2017 at 00:00 UTC.
Data
Gallery
-
A message telling the player they were loaned the Grizzco Blaster.
-
An Inkling holding the Grizzco Blaster after a shift.
Availability
The Grizzco Blaster was available during the following wildcard rotations:
Splatoon 3
Basic information | |
---|---|
Category | Main |
Class | Blaster |
Specifications | |
Base damage | 35 (Min. splash)
50 (Direct hit) |
Ink consumption | 3% |
The Grizzco Blaster returns in Splatoon 3, and is once again only available during wildcard rotations in Salmon Run. It was first available on 28 October 2022 at 08:00 UTC.
Data
- The Grizzco Blaster is a middleweight weapon.
- The ink consumption is 3% per shot, and 0.66% is recovered every shot, allowing the user to fire 42 shots on a full ink tank.
- When firing continuously, it shoots a bullet every 9 frames (6.67 shots per second).
- When firing from humanoid form, the first shot takes 14 frames to come out. When firing from swim form, the first shot takes 24 frames to come out.
- The interval between firing the weapon and being able to enter swim form or use a sub weapon is 6 frames.
- When firing while moving, the player's movement speed is set to 0.08 units per frame.
- After firing, there is a 5 frame cooldown before the ink tank starts refilling.
- The damage on direct hit is 50.
- The blast has a radius of 3.5 units and deals 35 damage.
- The bullet hitbox for collisions with players has a radius of 0.1 units.
- The bullet hitbox for collisions with the environment has a radius of 0.1 units.
- Shots cannot ever deviate from the inner reticle while on the ground.
- The angle its shots can deviate while in the air is 10.0 degrees.
- The outer reticle immediately expands after jumping. After 25 frames, the outer reticle will start shrinking, and will finish shrinking after 70 frames.
- When jumping, the chance to shoot towards the outer reticle instead of the inner reticle is immediately set to 50%.
- Shots initially travel straight at a rate of 0.87 units per frame for 7 frames. Shots travel straight for 6.09 distance units.
- After that, the shot's velocity is set to 0.8484 units per frame if it is not already lower than the listed value, and it loses 36% of its speed every frame (including the first frame after it stops traveling straight). Once the shot velocity decreases below a certain threshold, it will begin to be slowed less and fall faster.
- The bullet explodes 11 frames after being fired, covering a total distance of about 7.35 units.
- This number may vary at different firing angles.
Gallery
-
Held by the player
-
An Inkling posing with the Grizzco Blaster after successfully completing a shift
Availability
In Splatoon 3, the Grizzco Blaster was available during the following wildcard rotations:
Details
- The Grizzco Blaster has the same firing rate as the .52 Gal, shooting once every 3/20ths of a second.
Etymology
The weapon is a Blaster that was modified by Grizzco Industries.
Names in other languages
Language | Name | Meaning |
---|---|---|
Japanese | クマサン印のブラスター Kuma-san jirushi no burasutā |
Mr. Bear-branded Blaster |
Dutch | Beer & Co Blaster (Splatoon 2) Beer & Co-blaster (Splatoon 3) |
Grizzco Blaster |
French (NOA) | Blasteur M. Ours Cie | - |
French (NOE) | Blaster M. Ours SA | Mr. Bear Ltd. Blaster |
German | Bär-Blaster | Bear Blaster |
Italian | Blaster Ursus | Grizzco Blaster (Ursus = Mr. Grizz) |
Russian | Бластер «Потапыч Inc.» Blaster «Potapych Inc.» |
Blaster «Potapych Inc.» |
Spanish (NOA) | Lanzamotas Don Oso | Grizzco Blaster |
Spanish (NOE) | Devastador Don Oso | Grizzco Blaster |
Chinese (Simplified) | 熊先生印章爆破枪 xióng xiānshēng yìnzhāng bàopòqiāng (Mandarin) |
Mr. Bear Seal Blaster |
Chinese (Traditional) | 熊先生印章爆破槍 xióng xiānshēng yìnzhāng bàopòqiāng (Mandarin) |
Mr. Bear Seal Blaster |
Korean | Mr. 베어표 블래스터 Mr. beeopyo beullaeseuteo |
Mr. Bear Blaster |
Nonstandard main weapons in Splatoon 2
|